iii
No. 99MAM029A
Safety Precautions
Read the "Safety Precautions" thoroughly before operating to use the product properly.
As the precaution statements explained here address the contents to prevent the occur-
rence of safety hazards to others or damage to property, they are to be strictly observed.
Do not use the product in areas where volatile gases may be generated.
There is a risk of igniting the gas
.
• The product is intended for use with general machinery (measuring instruments, machine
tools, etc.).
Do not use the product with a control instrument whose operation faults or accidents can
cause direct bodily injury or death, such as medical equipment, aerospace equipment, trains,
and atomic power plant equipment. Please consult us in advance before using.
• Observe the following, since there is a risk of an electric shock or re.
• If the product starts to emit smoke or strange odors, or if it otherwise fails to operate correct-
ly, turn off the power switch immediately and disconnect the AC adapter from the electrical
outlet, then contact Mitutoyo or the agent where you purchased the product for repair.
• The product is not to be repaired or modied by the users.
• Use with the designated AC adapter.
• If the product is dropped or otherwise damaged, turn off the power switch and disconnect
the AC adapter from the electrical outlet, then contact Mitutoyo or the agent where you
purchased the product.
• Be sure to use the options specied in this manual for the options to be used with this prod-
uct.
Observe the following, since there is a risk of injury or re.
• Use the designated batteries. Use of non-designated batteries may cause a re or injury due
to rupturing or liquid leakage.
• Pay attention to the batteries' polarities and set them in as per the instrument’s indications
when setting them in the instrument. If they are mistakenly set in, that may cause rupturing or
liquid leakage.
• Do not apply excessive external force to the product. It may cause a failure or breakage.
• If foreign matter enters the product, turn off the power switch and disconnect the AC adapter
from the electrical outlet, then contact Mitutoyo or the agent where you purchased the product.
To Next Page
Loading...
General