12
2 Basic Operations
No. 99MAM029A
2.1.4 Date and Time Setting
When correcting time, set to the parameter setup mode ( "2.1.3 Printing the Parameter
Settings List" on page 11), and set the date and time by the following operation proce-
dure.
For further details on the parameter setup mode, refer to
"5.2 Various Parameter
Settings and Setting Items" on page 63.
1
Move the parameter set item to the date setting position in the parameter setup mode.
Press
DATA
repeatedly until "14 DATE"
is printed.
» Whenever
DATA
is pressed, the param-
eter set item/contents are printed by line
as shown in the right gure.
» The explanation on key operation for
date setting and the date currently set
are printed as shown in the right gure.
Tips
To change the date, calculate (count)
the number of changes from the
printed date, and go to
2
.
Date currently set
Explanation on
key operation
for date setting
2
Input the date. (If change is not required, go to
3
.)
1
Input "Year" by pressing
PRINTER
or
TOL.
REC/STOP
the necessary amount of times
from the current set value.
2
Input "Month" by pressing
CLEAR
the
necessary amount of times from the
current set value.
3
Input "Day" by pressing
the nec-
essary amount of times from the current
set value.
Day
(1 -> 2 ->
...
-> 31 -> 1)
Month
(1 -> 2 ->
...
-> 12 -> 1)
Year (2000 -> 2001 ->
...
-> 2100 -> 2000)
Year (2000 -> 2100 ->
...
-> 2001 -> 2000)
The date input is printed
POWER
TOL.
REC/STOP
PRINTER
CLEAR
STAT.
OUT LOG
CANCEL
DATA
FEED
Tips
• Press
STAT.
OUT LOG
to print the input date to check the input contents.
• Leap years and the number of days in a month are automatically calculated.
POWER
TOL.
REC/STOP
PRINTER
CLEAR
STAT.
OUT LOG
CANCEL
DATA
FEED
To Next Page
Loading...
General