Mitutoyo LGH Series User Manual

5
1 Overview
No. 99MBC122A
1.3
Operation Flow
The basic operation ow is explained below.
Do not omit the operations enclosed with a solid line. Perform the operations enclosed with a dashed
line as necessary.
Prep
Setup
"2 Setup" (page 7)
Parameter setting
"3 Parameter Setting" (page 17)
Measure
Prepare the workpiece
(Prepare the master workpiece as
necessary)
Tips
Perform adequate thermal stabilization of this
product and the workpiece. Turn on the power,
warm up the product for 30 minutes or more and
start measurement.
Set the tolerance
"4.6 Tolerance Value Setting" (page 34)
Set CEL-specic parameter
"4.7 CEL-Specic Parameter Setting" (page 37)
Zero setting/Preset
"4.3 Zero Setting" (page 32)
"4.4 Preset" (page 32)
Normal measurement/Peak mode
measurement
"4.5 Peak Mode Setting" (page 33)
Output
Result output
"5 External Input/Output Function" (page 41)

Mitutoyo LGH Series Specifications

General

Brand	Mitutoyo
Model	LGH Series
Category	Measuring Instruments
Language	English