No. 99MBC122A
iii
When using this product in the following environments, take necessary shielding measures.
y In locations subject to electric noise, such as from static electricity
y In locations subject to strong electric elds
y In locations near power supply lines/power lines
y In locations where it may directly exposed to chips, cutting uids, water, etc.
y In locations that may be exposed to radiation
y In locations that may be exposed to corrosive gas
Maintenance
Gently wipe dirt o of the product with a soft, tightly woven cloth. Do not use organic solvents such as
thinner or benzine.
Power source
• Turn o the power switch after use.
• Do not connect the AC adapter to high-current power used by machine tools or large CNC mea-
suring instrument.
• If you use a commercial power source, use a power cable measuring 30 m or shorter for the instru-
ment, and connect the instrument to the power source one-to-one.
• Use only a power source for this product that is rated at 12 V to 24 V and an output current of 1 A
or more. Never use this power source with other electric equipment that runs at a high voltage and/
or large current.
• Avoid outdoor wiring.
• Be sure to connect this product to ground.
• Connect the AC adapter to a grounding three-slot outlet.
Electromagnetic Compatibility (EMC)
This product complies with the EU EMC Directive. Note that in environments where electromagnetic
interference exceeds EMC requirements dened in this directive, appropriate countermeasures are
required to assure product performance.
To Next Page
Loading...
Need help?
General
