Mitutoyo LGH Series User Manual

28
3 Parameter Setting
No. 99MBC122A
3.4
Overview of Parameter Setting
This section gives an overview of parameter setting.
Tips
• The following gure does not illustrate the steps to set parameters.
• When setting parameters, each time you press [P.SET], the parameter number will advance from 00. When
the number advances to the last number, it then returns to 00.
• If you select a set value 1 (CEL-specic parameter setting) for Parameter Number 00, you go to Parameter
Number 40.When the number advances to 42, it then returns to 40.
• Be sure to set the parameters enclosed by a solid line.Set the parameters enclosed by a dashed line as
necessary.
Begin setting
(Parameter Number 00 = 0)
[09] Unit system selection
[11] Counter direction setting
[12] Linear Gage
resolution
Continued on the next page
Parameter

Mitutoyo LGH Series Specifications

General

Brand	Mitutoyo
Model	LGH Series
Category	Measuring Instruments
Language	English