Mitutoyo LGH Series User Manual

39
4 Basic Operations
No. 99MBC122A
4.8
Registering, Reading, and Clearing Memory
This section describes the procedure to register, read, and clear the memory.
Tips
This operation is available when the set value of Parameter Number 06 is 3 (memory).
z
Procedure for registering memory
1
Press [B_ZERO].
» The current value of Ach (upper display) is saved in Bch (lower display).
z
Procedure for reading saved data
1
Press [SEL] to select Bch (lower display).
2
Press [MODE] (switch to Peak setting mode).
» Each time you press [MODE], the displayed memory value cycles through the maximum value → minimum
value → run-out width.
z
Procedure for clearing memory
1
Press [SEL] to select Bch (lower display).
2
Press [P.SET].
» The values in the memory (maximum value/minimum value/run-out width) are cleared, and then the current
value in Ach (upper display) is displayed.

Mitutoyo LGH Series Specifications

General

Brand	Mitutoyo
Model	LGH Series
Category	Measuring Instruments
Language	English