a. Select Run... from the Start menu.
b. Enter winipcfg and click OK.
c. Select your ethernet adaptor from the pull-down menu
d. Click Release All and then Renew All.
e. Exit the winipcfg dialog.
Windows NT/Windows 2000/Windows XP
a. Bring up a command window.
b. Type ipcong/release in the command window.
c. Type ipcong/renew.
d. Type exit to close the command window.
Linux
a. Bring up a shell.
b. Type pump -r to release the lease.
c. Type pump to renew the lease.
Note
If you change the LAN IP address of the device while connected through your
Web browser, you will be disconnected. You must open a new connection by
entering your new LAN IP address as the URL.
From the left-hand Adminmenu, click on Commit/Reboot. The following page is
displayed:
Commit/Rebootpage
Click on OK.
To Next Page
Loading...
Need help?
General