6 - 12 MC9500-K Mobile Computer Integrator Guide
4. Select a ring tone for incoming calls from the Ring tone: drop-down list. To hear a sample of the selected ring
tone, tap . Tap to end the ring tone.
5. Select a keypad tone from the Keypad: drop-down list. This selection determines the tone that sounds when
entering a phone number on the keypad.
a. Select Short Tones for a tone that sounds only for one or two seconds.
b. Select Long Tones for a continuous sound for as long as the number on the keypad is pressed.
c. Select Off to disable tones.
6. Tap Other Settings... to set additional sounds and notifications for the MC9598-K.
7. Select the Notify me when voice privacy is unavailable check box to receive a message when dialing.
8. Tap ok to exit settings.
Location Settings
Use the Location tab to allow the network to detect the position of the MC9598-K’s radio.
1. Tap Start > Settings > Personal tab > Phone icon > Location Settings tab.
or
Start > Phone > Menu > Options > Location Settings tab.
Figure 6-22
Phone Window - Location Tab (Typical)
2. Select the Location ON radio button to allow the network to detect the position of the MC9598-K’s radio.
or
Select the
911 Only button to turn off location detection, hiding the location of the radio from all but 911
emergency service.
3. Tap ok to confirm Location ON or 911 Only.
4. Tap ok again to exit settings.
NOTE To use custom .wav, .mid or .wma files as ring tones, use ActiveSync on the host PC to copy the file to the
/Windows/Rings folder on the MC9598-K. Then, select the sound from the ring tone list.
NOTE Turning off sounds saves power and prolongs battery life.
To Next Page
Loading...
