2 - 10 MC9500-K Series Mobile Computer Integrator Guide
Four Bay Ethernet Cradle Wall Mounting
To mount the Four Bay Ethernet Cradle on a Universal Wall Mount bracket:
1. Connect the AC line cord to the power supply.
2. Route the AC line cord through the bracket.
3. Connect the DC cable to the power supply. Coil the DC cable so that it fits into the bracket.
Figure 2-12
Power Connections
4. Repeat for each cradle.
5. While holding the cradle close to the bracket, connect the DC Cable to the power port on the cradle.
6. Connect a Ethernet cable to the Ethernet Port 1 connector on the back of the cradle.
Figure 2-13
Four Bay Ethernet Cradle Connection
7. Route the Ethernet cable through the bracket to an ethernet hub.
8. Place cables neatly in the bracket and secure with tie wraps as required. Ensure that all cables are within the
bracket to avoid pinching wires.
Power Port
Ethernet Cable
Ethernet Switch,
Router, or Hub
Connection
Ethernet Port 1
DC Cable
To Next Page
Loading...
