Motorola MC9500-K Integrator Guide

Getting Started 1 - 7
Installing the Battery
To install the battery:
1. Insert the battery, top first, into the battery compartment.
2. Press the battery down into the battery compartment until the battery release latches snap into place.
Figure 1-10 Inserting the Battery
3. The MC95XX powers up automatically after inserting the battery, if the battery has been charged previously.
Charging the Battery
Before using the MC9500-K for the first time, charge the battery.
To charge the battery, use either a charging cable or a cradle:
• Cables:
• USB Charging Cable
• Charge Only Cable
• Cradles:
• Single Bay USB Cradle
• Four Bay Charge Only Cradle
• Four Bay Ethernet Cradle.
Align and hook the MC9500-K interface pocket onto the cradle’s or cable’s cleat. The battery automatically begins
charging. See Table 1-1 for charging indications. The 4800 mAh battery fully charges in less than six hours.
Battery
Battery Release Latch
Battery Release Latch
CAUTION Ensure that you follow the guidelines for battery safety described in Battery Safety Guidelines on page
10-2.
NOTE For cable and cradle setup and charging procedures see Chapter 2, Accessories.

Motorola MC9500-K Specifications

General

Brand	Motorola
Model	MC9500-K
Category	Handhelds
Language	English