8 - 4 MC9500-K Mobile Computer Integrator Guide
Wake Up on Motion
The Wake Up on Motion section provides configurable options for waking the MC9500-K from suspend mode by
shaking the MC9500-K.
Select Inactivity checkbox to allow IST to wake the MC9500-K when it was suspended due to inactivity.
Use the Change Sensitivity… button to configure the sensitivity settings.
Setting Sensitivity
Use the slider to set the sensitivity. A low setting indicates that a harder shake (faster movement) is required for the
IST to initiate a wake up action. The sensitivity can be set from “0” to “10” and when the sensitivity is set to lower
values a simple shake/motion can be detected by IST. A high setting allows IST to issue a wake up action when an
easier movement to the MC9500-K is detected. Shake the MC9500-K to test the set sensitivity. An audio sound is
heard and a message is displayed on screen when the shaking level reaches the set sensitivity level.
Figure 8-5
Set IST Sensitivity Window
Display Tab
Use the Display tab configure display interaction settings.
Figure 8-6
Display Tab
The Auto Orientation parameter controls the display rotation according to the MC9500-K orientation. Select the
Auto Orientation checkbox to enable this feature. Auto orientation is disabled by default.
To Next Page
Loading...
