Motorola MC9500-K - Handstrap Replacement

Getting Started 1 - 13
Handstrap Replacement
To remove the handstrap:
1. Press the Power button to place the MC9500-K in suspend mode.
2. Wait for the Decode LED to light red and then turn off.
3. Unhook the handstrap from the handstrap bar.
4. Remove the two screws securing the handstrap bar to the housing.
Figure 1-15 Remove Screws Securing Handstrap Bar
5. Remove the battery.
6. With the handstrap slot pointing upward, push the handstrap into the slot of the housing slightly to provide
slack.
Figure 1-16 Push Handstrap Loop into Slot
7. Grasp the end of the handstrap and turn it sharply/tug to dislodge the pin and remove the handstrap.
Handstrap Bar
Screw
NOTE A pin holds the loop end of the handstrap in the housing slot.