Motorola MC9500-K - Page 32

1 - 14 MC9500-K Mobile Computer Integrator Guide
Figure 1-17 Turn Pin and Loop
8. Remove the loop end of the handstrap and pin from the housing slot.
To replace a new handstrap:
1. Pinch the loop end of the new handstrap and insert the loop into the housing slot. Ensure that the loop is
completely inserted into the housing slot.
Figure 1-18 Insert Strap and Pin into Slot
2. In the battery compartment area, insert the pin into the loop of the handstrap.
Figure 1-19 Insert Pin into Loop
3. Ensure that the pin is centered in the loop.