2 - 22 MC9500-K Series Mobile Computer Integrator Guide
Single Bay USB Cradle
This section describes how to set up a Single Bay USB cradle. For USB communication setup procedures see
Chapter 3, ActiveSync.
The Single Bay USB Cradle:
•
Provides 5.4 VDC power for operating the MC9500-K.
•
Synchronizes information between the MC9500-K and a host computer. See Chapter 3, ActiveSync for
information on setting up a partnership between the MC9500-K and a host computer.
•
Charges the MC9500-K’s battery.
Setup
Figure 2-32
Single Bay USB Cradle Power and USB Connections
1. Connect the power supply DC line cord to the power port on the back of the cradle.
2. Plug the AC line cord into the power supply.
3. Plug the AC line cord into an AC outlet.
USB Port (micro-AB)
Power Supply
Power Port
AC Line Cord
USB Sync Cable
(USB micro-B to USB A)
DC Cable
NOTE Ensure that the correct USB Sync cable is used. The cable must have a USB micro-B connector.
To Next Page
Loading...
