Motorola MC9500-K - Four Bay Charge Only Cradle Wall Mounting

2 - 14 MC9500-K Series Mobile Computer Integrator Guide
Figure 2-18 Four Bay Ethernet Cradle LED Indicators
Four Bay Charge Only Cradle Wall Mounting
1. Connect the AC line cord to the power supply.
2. Route the AC Line Cord through the bracket.
3. Connect the DC line cord to the power supply. Coil the DC cable so that it fits into the bracket.
Figure 2-19 Power Connections
4. Repeat for each cradle.
5. While holding the cradle close to the bracket, connect the DC line cord to the power port on the cradle.
Speed LED
(Green)
Link LED
(Yellow)
DC Cable
AC Line Cord