ioThinx 4510 Series Quick Start Guide
If you see the module settings page as opposed to the dashboard, click Edit to enter the edit mode and
start editing the module settings.
In edit mode, if any detected module and configured module do not match, the configured module will be
highlighted as shown below.
Click Auto Matching to match the conflicted modules.
If not, you can use the “Auto Match” function or swap the module to change the module sequence.
If you want to re-arrange the 45MR modules automatically, you can click “Auto Match”.
If you want to change configurations, you can use the swap function. To swap the module sequence, move
the point to the module, click the left button on the mouse and hold it. After the module color changes to
green, you can move it to change the position of the module.
To Next Page
Loading...
Need help?
General
