Command #178: Write Gas Table
Writes the Ultima X Gas Table selection. The Ultima Gas Monitor uses
the Gas Table value to select a reference table of linearization values
for certain sensors.
Request Data Bytes
BYTE FORMAT DESCRIPTION
0 Unsigned Gas Table selection number (see TABLE D-10)
Response Data Bytes
BYTE FORMAT DESCRIPTION
0 Unsigned Gas Table selection number
Command-Specific Response Codes
CODE CLASS DESCRIPTION
0 Success No Command-Specific Errors
1-2 Undefined
3 Error Parameter too large
4 Error Parameter too small
5 Error Too few data bytes
6 Undefined
7 Error In write protect mode
8-15 Undefined
16 Error Access Restricted
17-31 Undefined
32 Error Busy
33-127 Undefined
D-19
To Next Page
Loading...
Need help?
General
