Command #183: Write Calibration Abort
This command writes a calibration Abort command to the Ultima Gas
Monitor. The calibration abort command instructs the device to suspend
the calibration sequence initiated by the calibration mode command.
Valid number for this command is 1.
Request Data Bytes
BYTE FORMAT DESCRIPTION
0 Unsigned Calibration Abort Command number
Response Data Bytes
BYTE FORMAT DESCRIPTION
0 Float Calibration Abort Command number
Command-Specific Response Codes
CODE CLASS DESCRIPTION
0 Success No Command-Specific Errors
1-2 Undefined
3 Error Parameter too large
4 Error Parameter too small
5 Error Too few data bytes
6 Undefined
7 Error In write protect mode
8-15 Undefined
16 Error Access Restricted
17-31 Undefined
32 Error Busy
33-127 Undefined
D-24
To Next Page
Loading...
Need help?
General
