To Next Page

To Previous Page

Additional Sensor status screen

Zero Fault

The Zero Fault can be caused by a faulty sensor, calibration out of the

Standard Zero/Span calibration range, sensor in change, sensor fault or

attempting to zero the sensor with Span gas applied. The application of

Zero gas should be checked and the sensor status (as defined in

FIGURES D-16 and D-18) verified if this fault occurs.

Figure D-18. Additional Sensor Status screen

D-57

Other manuals for MSA Ultima X Series

Questions and Answers:

Need help?

Do you have a question about the MSA Ultima X Series and is the answer not in the manual?

General