To Next Page

To Previous Page

NOTES:

Grounding

• Incoming power and signal cable shield should be earth grounded

at the power source.

• Connect power and remote sensor cable shields to shield terminals

on main pc board.

• Provide shield terminations inside the sensor housing as indicated

on Installation Outline Drawings for Remote Sensor. See

TABLE 1-1 for Installation Outline Drawing document numbers.

Cable Size

• Cables larger than #16 AWG will require a splice of smaller cable

to fit the connector.

1-23

Other manuals for MSA Ultima X Series

Questions and Answers:

Need help?

Do you have a question about the MSA Ultima X Series and is the answer not in the manual?

General