© Munters AB, 2020 109
NOTE Testing takes place at the scheduled time. If there is a delay for any reason (for
example, a power outage), the test will not take place more than five (5) minutes after
the scheduled time.
16.2
Viewing the Alarms
•
On the Main Menu bar, click .
•
Click to acknowledge all alarms or acknowledge each one as
required.
16.3
Defining the Auxiliary Alarms
The auxiliary alarm provides an additional method for adding alarm functions to specific
relays. This function compares the relay’s current state to its defined state (normally open,
normally close). If the relay is not in its defined state, Trio sends an alarm. You can define
the auxiliary alarms to operate during specific time periods. Use this alarm for those relays
controlling important functions.
Define at least one sensor as an auxiliary input in Devices and Sensors.
1. Go to Control > Auxiliary Alarm
To Next Page
Loading...
Need help?
General
