© Munters AB, 2020 95
NOTE In multi-line mode devices may have different intensity settings; dimming rate
should be calculated for each line separately.
At 5:40 Line 1 and Line 2 turn on. Both reach their intensity (45% and 55% respectively) at
6:00. At 8:10, Line 1 begins to increase its intensity and Line 4 turns on. Both Line 1 and
Line 4 reach 60% at 8:30. At 19:00 all lines begin to turn off, turning off completely at
19:20.
12.3
Light Settings
Trio can generate an alarm when lights go below a user-defined level.
This function requires a light sensor. Refer to the Installation Manual.
1. Go to Control > Light > Settings and enable Light intensity alarm.
2. Define the minimum light intensity that lights must achieve. Below this level, Trio
generates an alarm.
To Next Page
Loading...
Need help?
General
