Munters Trio Poultry Controller - Heat Cycles

© Munters AB, 2020 67
2. Define the Minimum Heater Output. Range: 0 – 100%
9.2.2 H
EAT
C
YCLES
To enable running heaters in a cycle:
1. Go to System > Control Strategy > Climate .
2. Enable Heater Cycle.
3. Go to Climate > Heating > Settings.
4. Define:
o
Total Cycle Time (sec.): Range 5 – 600 seconds. Default 300 seconds
o
Minimum Cycle On Time (sec): Range 5 – 600 seconds. Default 60 seconds
o
Minimum Cycle Off Time (sec): Range 5 – 600 seconds. Default 30 seconds