Redial
Manual redial
The destinations for the last 10 fax transmissions and phone calls are stored
in the machine's memory.
1
Press <Fax>.
2
Load your document.
3
Press the upper cursor key.
Fax Ready Fax Mode
2 Apr 2007 13:30 Memory:100%
Resol.
Normal
Contrast
Normal
ScanSize
Auto
1/2
4
Select the destination using the cursor keys and press [Enter].
Redial 1/4
01:0751234567
02:0666667777
03:0792111111
Close
Enter
5
Press <Start>.
Scanning the document starts.
• Numbers dialed using the numeric keys on the handset will not be memorized.
• Up to 40 digits of the dialing number per one transmission can be memorized.
Auto redial
If the other party’s line is busy or if there is no answer, the machine waits
one minute (or three minutes in some countries), then tries to dial the same
number again. The machine will attempt the redial up to two times.
Fax Ready Redial
2 Apr 2007 13:30 Memory: 99%
Resol.
Normal
Contrast
Normal
ScanSize
Auto
1/2
• The number is not automatically redialed in the manual transmission.
• When the auto redial is standby, the “Redial” message is displayed on the
screen.
• You can change the number of times the machine attempts to redial and
the time interval the machine waits between redialing attempts.
For details on settings, refer to “Other Settings” (page 8-17) in the fax-
related settings.
• To cancel the auto redial, press <Job Confirm./Fax Cancel> to delete the
reserved command. For details on canceling the communication, refer to
“Canceling/Checking Fax” (page 3-21).
DB2-90290-60.indb 12 2007/02/02 12:32:42
To Next Page
Loading...
Need help?
General
