Reading a journal report
Printout example
1 2 3 4 5 6 7 8 9
1. No.
The number of the communication.
2. Name
Recorded in the following order.
(1)
Destination name registered in the
speed dials etc. (transmission only)
(2) Telephone number registered in
the speed dials etc. or specified
using the numeric keys.
(transmission only)
(3) Sender ID registered in the
other party
(4) Sender number registered in
the other party
(5)
Blank
3. Mode
Resolution in the communication.
4. Start Time
Time to start the communication.
5. Time
Time required from the start to the
end of the communication.
6. Page
Number of pages communicated
normally.
If a transmission error occurs, the
other party may have printed the
page on which an error occurred.
7. Dept
When the department management
is set, the department number is
recorded here.
8. Result
Communications results.
• OK
Completed normally.
• *
Communicated in ECM mode.
• #
Communicated via Super G3.
• Error codes
Finished abnormally Transmit again. (For more
details about the error code, refer to page 9-20.)
9. Note
•
Polling
Indicates the polling.
•
F-Tx
Indicates the F-code transmission.
• F-Poll
Indicates the F-code polling.
•
F-Secur
Indicates the F-code security box
communication.
•
F-Relay
Indicates the F-code relay
command communication.
•
F-Bull
Indicates the F-code bulletin box communication.
• Brdcast
Indicates the broadcast communication.
• Manual
Indicates the manual transmission or reception.
• Forward
Indicates the fax forward communication.
To Next Page
Loading...
Need help?
General
