Press [Yes] to program the steps (operations) that have been completed to include
<Start>. Press [No] to program the steps (operations) up to just before <Start>.
• You can use this function as follows:
While programming the transmitting operation, press [No], excluding <Start>
in a macro. Then, when you press the programmed macro key, all steps just
before <Start> is pressed will be performed. After that, you can set the delayed
transmission and so on.
If you press [Yes] and include <Start> in the macro, the fax will be automatically
transmitted. Therefore, you cannot set anything such as a delayed transmission.
[Example] Transmission
Document
scanning
Transmit
A.
Perform to this step
B.
Perform to this step
A. <Start> excluded
B. <Start> included
Changing a macro name
You can change the titles of the programmed macro keys.
1
Press <Macro Program>.
2
Select “Edit Title” using the cursor keys and press [Enter].
To Next Page
Loading...
Need help?
General
