Muratec mfx-2200 User Manual

9-20
Error codes
D: Dialing Errors
Mode
Error
codes
Description of code Countermeasure
G3 Transmission
D.0.1 Transmission and reception
occurred simultaneously.
Resend the document.
D.0.2 Receiving line is busy Resend the document.
D.0.3 <Stop> was pressed Resend the document.
D.0.6
The receiving fax number is not
registered when using the auto-
dial function
Set the correct fax number and then
resend the document.
D.0.7
The receiving party did not
answer when using the auto-dial
function
Set the correct fax number and then
resend the document.
D.0.8
A dial tone cannot be detected.
Check the line cable is connected
properly.
Check the dial tone detect settings.
T: Transmission Errors
Mode
Error
codes
Description of code Countermeasure
G3 Transmission
T.1.1
Wrong number (receiving party
answered and hung up)
Check the correct fax number and resend
the document.
The receiving party answered
manually and hung up the phone
Check the receiving method on the other
machine.
The other machine is not a G3
machine
This machine cannot communicate with
it.
T.1.4
Transmission is canceled when
starting the communication
(only displayed in the auto print
journal)
Resend the document.
T.2.1
The line status was bad
(especially when communicating
overseas) and the receiving party
cut off the line
Resend the document. If this error occurs
repeatedly, contact your authorized
Muratec dealer.
Your machine's settings do not
match with the other machine's
Check the settings on the other machine.
If the receiving party has special
settings, ask him/her to release them.
T.2.2
Your machine's settings do not
match with the other machine's
Check the model and setting status on
the other machine.


DB2-90290-60.indb 20 2007/02/02 12:34:23

Muratec mfx-2200 Specifications

General

Brand	Muratec
Model	mfx-2200
Category	All in One Printer
Language	English