4-42
4.2.2 Connecting to the FP0
Connecting to the COM. port
Connecting to the FP0 COM. port
Note:
• Because loose wiring is used for connection to the FPΣ COM. port, no dedicated cable is available.
The cable should be provided by the customer. When purchasing a cable, the following precautions
should be observed.
• Shielded wire with a size of AGW#28 to 16 (conductor cross-section surface area: 0.08 mm
2
to 1.25
mm
2
) should be used for connections.
To Next Page
Loading...