2-3
2.1.2 GT01 and GT11 Installation Method
Secure the GT to the installation panel using the four fittings and four screws provided with the unit.
1. Place the GT main unit in the installation panel.
2. Insert the fittings into the grooves provided in the GT main unit, and tighten the screws to
secure the GT main unit to the installation panel.
Note:
Screw tightening torque
The screw tightening torque should be 0.1 N m to 0.25 N m. Tightening screws too hard may be a cause
to deform the case and other parts, and may cause to deteriorate the waterproof property or damages in
the functions.
Applicable panel thickness
A panel with a thickness of 1.0 to 5.0 mm should be used.
Clearance when the GT is installed
When installing the GT, if other parts are being installed to the panel or cables are being wired to it, we
recommend providing a clearance of 30 to 50 mm around the GT. This prevents cables from being
damaged, and facilitates the installation work. Also, make sure that the slits in the main unit are never
obstructed.
When using the GT11 connecting our Programmer II or C-NET adapter to the TOOL port
Usable ambient temperature is 45 °C.
To Next Page
Loading...