5-3
5.2 Entering Configuration Settings from GTWIN Screen
Creation Tool
This section describes how configuration settings for the GT main unit are entered from GTWIN screen
creation tool.
Opening the GT Configuration Settings
The GT configuration settings are set by selecting [Configuration] on the menu displayed by clicking with
the mouse on [File] or pressing the Alt + F keys. Then select the “GT Configuration” sub-menu under
[Configuration].
Configuration Settings
GTWIN Configuration: These are operating environment settings for GTWIN.
GT Configuration: These are configuration settings for the GT main unit. The file is sent from
GTWIN to the GT main unit after the settings have been entered.
5.2.1 GT Configuration Settings: “Basic Setup”
Selecting [Configuration] on the [File] menu of GTWIN and then the sub-menu [GT Configuration]
displays the “Basic Setup” screen shown below.
This is used to specify the basic communication area used for communication between the GT main unit
and PLC, and the environment required for the GT main unit operation.
“Basic Setup” screen (for GT01)
The [Hold PLC device] and [Alarm history]
settings are not available for GT01.
To Next Page
Loading...