5-10
5.2.5 GT Configuration Settings: “Setup” (For GT01)
Clicking on the “Setup” tab in the “GT Configuration” dialog box displays the screen shown below. Here,
clock functions, backlight control, and other parameters can be specified.
“Setup” screen
Clock
This is used to specify the reference destination for the clock displayed with the GT01.
PLC Clock
When the time is displayed, the internal clock in the PLC is used as a reference for the value.
If the “PLC Clock” is referenced for the clock setting, clicking on the
button displays a screen where
the type of device and the address can be specified.
Device Setting dialog box
Click on the button to display the pull-down menu, and select
the device from that menu. Enter the address using the ten-keys.
The
button functions as a backspace key when entering
addresses. The
button acts as a Clear key.
To Next Page
Loading...