2-4
2.1.3 GT30 Installation Method
Secure the GT30 to the installation panel using the two fittings and four screws provided with the unit.
1. Place the GT30 main unit in the installation panel.
2. Insert the fittings into the grooves provided in the GT30 main unit, and tighten the screws to
secure the GT30 main unit to the installation panel.
Note:
Screw tightening torque
The screw tightening torque should be 0.1 N m to 0.25 N m. Tightening the screws too hard can cause
deformation of the front panel, so that the switch will not function properly. Make sure screws are
tightened to the appropriate degree.
Applicable panel thickness
A panel with a thickness of 1.0 to 5.0 mm should be used.
Installation angle and ambient temperature range for usage
If the unit is being installed in a horizontal orientation and the Matsushita Programmer II and C-NET
adaptor are being connected to the TOOL port, please be aware that the ambient usage temperature
should not exceed 40 °C.
Clearance when the GT is installed
When installing the GT30, if other parts are being installed to the panel or cables are being wired to it,
we recommend providing a clearance of 30 to 50 mm around the GT30. This prevents cables from being
damaged, and facilitates the installation work. Also, make sure that the slits in the main unit are never
obstructed.
To Next Page
Loading...