5-15
5.2.7 GT Configuration Settings: “Setup” (For GT30)
Clicking on the “Setup” tab in the “GT Configuration” dialog box displays the screen shown below. Here,
clock functions, backlight control, and other parameters can be specified.
“Setup” screen
Clock
This is used to specify the reference destination for the clock displayed with the GT30. Select one of the
radio buttons.
• GT Clock:
• PLC Clock:
When the time is displayed, the internal clock in the GT30 is used as a reference for
the value.
When the time is displayed, the internal clock in the PLC is used as a reference for
the value.
If the “PLC Clock” is referenced for the clock setting, clicking on the
button displays a screen where
the type of device and the address can be specified.
Device Setting dialog box
Click on the button to display the pull-down menu, and select
the device from that menu. Enter the address using the ten-keys.
The
button functions as a backspace key when entering
addresses. The
button acts as a Clear key.
Transfer Outside
Clock data displayed in the GT30 can be transferred to an external device such as a PLC, using this
setting.
• Off:
• On
The GT30 clock data is not transferred to an external device.
The GT30 clock data is transferred to an external device.
If “On” is selected for the above “Transfer Outside” parameter, click on the
button to specify the
output destination and the initial device, and specify the address.
To Next Page
Loading...