NAiS GT Series - Connecting to the TOOL Port of FP10 SH (1) (Direct Connection to GT01)

4-6
4.1.5 Connecting to the TOOL port of FP10SH (1) (Direct Connection to GT01)
Connecting to the TOOL port
Connecting to the FP10SH TOOL port
Please create a cable from the following contents.
Note:
• Keep the cable no longer than 3 m.
• When supplying power from the TOOL port, verify whether or not it will be possible by using the
method of calculation for the number of expansion units that is provided in the FP10SH manual.