5-9
5.2.4 GT Configuration Settings: “Startup Screen Set tings”
Clicking on “Start-up Screen” in the “GT Configuration” dialog box displays the screen shown below.
Here, the screen displayed when the GT main unit is booted can be specified.
“Start-up Screen” screen
This is used to specify the screen that will be displayed when the GT main unit is booted, as well as the
time it will be displayed. Clicking on the
button for each of the items displays a “Value Set” dialog box
where the values can be specified.
• Start-up Screen:
• Display time:
This specifies the number of the screen that will be displayed when the GT is
booted. Clicking on the
button displays a “Value Set” dialog box where the
value for the start-up screen number can be specified.
This specifies the time for which the startup screen specified above will be
displayed. The value can be set to any number between 0 and 255 seconds.
Clicking on the
button displays a “Value Set” dialog box where the start-up
delay time can be specified.
Key Point:
• When the above settings are entered, the screen specified with the “Startup Screen” parameter is
displayed for the amount of time specified with the “Display Time” parameter.
• When the amount of time specified with the “Display Time” parameter elapses, the screen
corresponding to the number stored in the initial address of the word device under “Basic
Communication Area to PLC” in the Basic Setup” parameters under “GT Configuration” will be
displayed.
• This function is used when it is necessary to delay the start-up time when the power supply on the
PLC side is turned on.
Note:
• Communication between the GT main unit and the PLC (external device) cannot be carried out during
the time specified by the “Display Time” parameter. Therefore, the switch part nor lamp part will not be
displayed even if they are pasted on the start-up screen.
To Next Page
Loading...