NAiS GT Series - Connecting to the TOOL Port of FP-M (1) (Direct Connection to GT01)

4-8
4.1.7 Connecting to the TOOL port of FP-M (1) (Direct Connection to GT01)
Connecting to the TOOL port
PLC communication cable: Mini-DIN 5-pin loose-wire cable (AIGT8142)
Connecting to the FP-M TOOL port
Note:
• Keep the cable no longer than 3 m.
• Use an external power supply for the GT01 when connecting to the TOOL port of a fully expanded
control unit.