NAiS GT Series - GT Configuration Settings: Auto-Paging

5-8
5.2.3 GT Configuration Settings: “Auto-Paging”
Clicking on “Auto-Paging” in the “GT Configuration” dialog box displays the screen shown below. Here,
settings can be entered for a function that automatically switches the screens displayed on the GT main
unit.
“Auto-Paging” screen
Auto-paging
This is used to specify the “Auto-paging function”, which automatically switches the specified screen
when a given period of time has elapsed.
• Off:
• On:
The screen is not switched automatically.
The screen is switched automatically, in conformance with the specified contents.
Auto-paging settings
If “On” is selected for auto-paging, and the [Setup] button is clicked, a dialog box containing the following
auto-paging settings is displayed.
Clicking on the
button for “Screen No.”, “Time”, or “Jump to” displays a “Value Set” dialog box. Set
the value and click the [Save] button to save values one at a time.
• Screen No.:
• Time:
• Jump to:
• [Return]:
• [Delete]:
• [Save]:
This specifies the screen targeted for auto-paging.
This specifies the time for which the screen specified above is displayed. The setting
range is from 1 to 255 seconds.
This specifies the number of the next screen to be displayed.
This completes the auto-paging settings and returns to the “Auto-Paging” dialog box.
This deletes screens registered for auto-paging.
This saves the settings for the screen number, time, and jump destination as auto-
paging settings.