NAiS GT Series - Connecting to the TOOL Port of FP2; FP2 SH (1) (Direct Connection to GT01); Connecting to the TOOL Port of FP2; FP2 SH

4-4
4.1.3 Connecting to the TOOL port of FP2 / FP2SH (1) (Direct Connection to
GT01)
Connecting to the TOOL port
Reference: <4.1.15 How to Make Communication Settings Using the FPWIN GR>
PLC communication cable: Mini-DIN 5-pin loose-wire cable (AIGT8142)
Connecting to the FP2/FP2SH TOOL port
Note:
• Keep the cable no longer than 3 m.
• When supplying power from the TOOL port, verify whether or not it will be possible by using the
method of calculation for the number of expansion units that is provided in the hardware manual.