3-5
3.2.2 Settings in GTWIN
Select “Configuration” under “File” on the menu bar, and then select the sub-menu called “GTWIN
Configuration”. This displays the dialog box for the GT Basic Setup, as shown below.
Clicking on the
button in “Basic Communication Area to PLC” displays the device settings dialog box
shown below, where the initial addresses for the word area and bit area can be changed.
GT Configuration Basic Setup dialog box
Explanation of this function:
Key operaiton in the Device Settings dialog box
Click on the
button to display a pull-down menu, and then select the device for which settings are to
be entered. Use the ten-keys to enter the address.
The
button acts as a backspace key when entering an address, and the button functions
as a Clear key.
To Next Page
Loading...