4-60
Setting the communication conditions
Setting communication conditions on the GT side
Set the COM. port communication conditions as follows.
Item Value set
Baud rate 19200 bps
Data length 7 bits
Parity check Yes, Even
Stop bit 1 bit
Setting communication conditions on the PLC side
Set the communication conditions as follows. Some items cannot be set depending on the used model.
There is no need to set the items that are not available.
Item Value set
PLC mode Monitor mode
Mode designation High link
Procedure 1:N
Baud rate 19200 bps
Data length 7 bits
Parity check Yes, Even
Stop bit 1 bit
Unit No. No. 0
CTS designation Always ON
5 V supply None
Communication system RS232C
To Next Page
Loading...