3-3
3. Transfer the GT Configuration file from GTWIN
After connections have been completed, use the following procedure to transfer the GT Configuration file
from GTWIN.
• Boot GTWIN, and select
“Transfer” on the “File” menu.
• When the transfer function is selected, a dialog box for
file transfer is displayed. At this point, specify the type of
data to be transferred, and the direction of transfer.
Transfer data: “GT Configuration”
Transfer direction: “GTWIN → GT main unit”
Enter the above conditions and click on the “OK” button.
The system files are transferred to the GT main unit.
When the menu oepration as above is carried out, the configuration file sent to the GT main unit. During
the transfer, a screen like that shown below is displayed.
Setup is completed.
If the transfer has been completed without any problems, the setup is completed.
Note:
• Backup of the GT Configuration file
The GT Configuration file is stored in the user memory (F-ROM) of the GT main unit. This file is deleted
if the memory is initialized using the command on the system menu of the GT main unit, and will have
to be transferred again.
To Next Page
Loading...