4-38
Setting the communication conditions
Setting communication conditions on the GT side
Set the COM. port communication conditions as follows.
Item Value set
PLC unit No. 1
Baud rate 19200 bps
Data bit 8
Parity check None
Stop bit 1 bit
Setting communication conditions on the PLC side
Set the communication conditions as follows. Some items cannot be set depending on the used model.
There is no need to set the items that are not available.
Item Value set
Unit No. 1
Baud rate 19200 bps
Data bit 8
Parity check None
Stop bit 1 bit
Checksum None
Termination character designation Available
Usable devices
Device type No. Remarks
Input relay X00201 to X71664
Designate the slot No. (1 digit) + unit No. (2
digits) + terminal No. (2 digits).
Output relay Y00201 to Y71664
Designate the slot No. (1 digit) + unit No. (2
digits) + terminal No. (2 digits).
Internal relay I00001 to I16000
Link relay L00001 to L08192
Designate the system No. (1 digit) + link
relya No. (4 digits). The system No. 0 is
only available.
Timer T0001 to T3072
Bit
device
Counter C0001 to C3072
Input relay X00201 to X71649
Designate the last 2 digits of the address to
be 17, 33, 49.
Output relay Y00201 to Y71649
Designate the last 2 digits of the address to
be 17, 33, 49.
Internal relay I00001 to I15985
Designate the address in increments of the
values of which reminder is 1 when being
devided by 16.
Link relay L00001 to L08177
Designate the address in increments of the
values of which reminder is 1 when the last
4 digits are devided by 16.
Timer (current value) TP0001 to TP3072
Counter (current value) CP0001 to CP3072
Data register D00001 to D65535
Link register W00001 to W08192
Designate the system No. (1 digit) + link
register No. (4 digits). The system No. 0 is
only available.
Word
device
File register B00001 to B99999
To Next Page
Loading...