MASCHINE 1.5 Reference Manual – 126
The outer ring of the knobs, used for displaying automation
To remove the Automation, simply right-click (on Mac: Control-click) on that outer ring.
Alternatively you can also select individual automation points in the Automation Lane and
right-click (on Mac: Control-click) on them.
To edit the Automation, drag the automation points in the Automation Lane. You can select
several automation points in the Automation Lane together by clicking and dragging a rect-
angle around them; now you can edit them by dragging them up or down. You will see that
they keep their relative distance although they change their absolute values.
%
Double-clicking creates an Automation event and replaces the others on this Step.
The Automation Lane with the Velocity parameter in focus
To Next Page
Loading...
