MASCHINE 1.5 Reference Manual – 176
The Scene Mode on the hardware
Software
►
Select the Scene by clicking on the Scene Label in the Arranger Area. It will now be
highlighted in white:
Selecting Scene 1
10.2 Creating and deleting a Clip in the Arranger
Each Clip placed in the Clip Area of the Arranger references one of the Patterns created in
the Pattern Editor. Therefore, when a Pattern or any of its content is edited, all referencing
clips in the Arranger will automatically get updated accordingly. The length of a given Scene
always corresponds to the longest Pattern of this Scene.
Hardware
1. Enter Pattern Mode by pressing PATTERN and lock it by pressing Button 1 at the same
time if you want.
2. Choose your Pattern by selecting it with the Pads.
To Next Page
Loading...
