MASCHINE 1.5 Reference Manual – 178
%
If you have a mouse that is equipped with a scroll wheel, you can also create Clips by
hovering over the empty Clip Area while scrolling up or down. As you scroll, you will
notice that the Patterns can be selected quickly using the scroll wheel!
10.3 Scene Sync
Scene Sync allows you to quantize the Scene transitions. For example, you might not want
a newly selected Scene to re off immediately—you might want it to wait until the next bar
line. The available quantization values are 1/1 (= one bar), ½, ¼, 1/8, Scene and Off. If you
choose Off, the Scene change will be performed immediately after you select the next Scene.
Hardware
The Scene Sync on the hardware
► Press GRID+Button 2; using the Pads, you can now select a Scene Sync.
rEtrIGGEr
If rEtrIG is enabled (by turning Knob 1), the next Scene
you select will be forced to play from the start. This is use-
ful if you always want your Scenes to play from the begin-
ning regardless of what’s happening elsewhere in the mu-
sic. If rEtrIG is set to oFF, the next Scene you choose will
be played according to the Scene Sync selected and at the
current position of the previously selected Scene: i.e., leav-
ing the rst Scene on beat 3 will cause the new Scene to
start playing on its beat 3. If you have set Scene Sync to
oFF, the Scene change will happen immediately.
To Next Page
Loading...
Need help?
General
