MASCHINE 1.5 Reference Manual – 181
10.5 Copy and Paste Scenes
Hardware
►
To copy a Scene to another Scene Slot, press and hold DUPLICATE. Press the Pad of
the Scene you want to copy, and then the target Pad for the Scene copy.
Software
1. Right-click (Ctrl-click on the Mac) on Scene labels opens the Scene menu.
2. Select Copy from the Scene menu of the Scene you want to copy.
3. Select Paste from the Scene menu of the target Scene Slot.
10.6 Using the Loop Mode to combine scenes
A single selected Scene is always looping automatically. The Loop Mode allows you to se-
lect several consecutive Scenes and play them one after the other in a Loop. This is useful
to check if the Scenes go well together and/or if the arrangement works, but also comes in
handy in a live situation.
Hardware
1. Enter Scene Mode by pressing the SCENE and lock it by pressing Button 1 at the same
time. The loop range can be dened by selecting a start Scene and an end Scene.
2. Select the starting Scene by pressing the corresponding Pad.
3. While holding the rst Pad, press the Pad corresponding to the end Scene.
→ Now you will hear the rst Scene and the second Scene in sequence. Any Scene in
between those two will be integrated in the Loop.
%
To disable the Loop again, just select another Scene by pressing a Pad in Scene Mode.
To include all Scenes in the Loop, hit Button 2 (ALL).
To Next Page
Loading...
Need help?
General
