Native Instruments Maschine - Aux Pre and Post

MASCHINE 1.5 Reference Manual – 96
Main
oUtpUt
This is used to dene where you want to send your Group.
Available options are Master, all Sounds with Input enabled,
the External Outputs 1-8 and None.
lEvEl Here you adjust the volume level of your Group.
pan Denes the pan position of your Group in the stereo eld.
Aux 1
dEStInatIon
The destination for Aux 1: available destinations are
Master, all Sounds with Input enabled, the External
Outputs 1-8 and None.
lEvEl
Here you adjust the amount of the signal that gets sent to the
Aux 1 destination.
Aux 2
dEStInatIon
The destination for Aux 2: available destinations are
Master, all Sounds with Input enabled, the External
Outputs 1-8 and None.
lEvEl
Here you adjust the amount of the signal that gets sent to the
Aux 2 destination.
5.2.2 Page 2: Aux Pre and Post
Page 2 of 2 from the Group Out Tab Parameters on the hardware