Native Instruments Maschine - Modulation Envelope and Destination

MASCHINE 1.5 Reference Manual – 71
Filter Modes
The modE menu in the Filter section gives you access to a set of different lters. Using the
arrows you can choose from different lter types: EQ, HP2, BP2, LP2 and Off. Each type
results in different parameters to the right of it:
Filter Controls
EQ The EQ is an equalizer with FrEQUEnCy, BandwIdth and GaIn.
HP2
HP2 is a highpass lter with CUtoFF and rESonanCE. Cutoff
can be modulated by Velocity, the Modulation Envelope,
the LFO or the MIDI Modulation Wheel.
BP2
BP2 is a bandpass lter with CUtoFF. CUtoFF can be modu-
lated by Velocity, the Modulation Envelope, the LFO or the
MIDI Modulation Wheel.
LP2
LP2 is a low pass lter with CUtoFF and rESonanCE. CUtoFF
can be modulated by Velocity, the Modulation Envelope,
the LFO or the MIDI Modulation Wheel.
4.3.1 Page 4: Modulation Envelope and Destination
Page 4 of 6 from Sampler Source Tab on the hardware
Page 4 of 6 from Sampler Source Tab on the software