Native Instruments Maschine Reference Manual

MASCHINE 1.5 Reference Manual – 199
11.2.2 Editing a Sample (Software)
In the Edit Tab, you can do the following: adjust Start and End of the Sample, enable Loop
Mode, adjust Start and End Points of the Loop, or set a Crossfade between the End and the
Start point of the Loop.
The Edit Tab on the software
1 Start and End of the Sample
Adjust the Start and End point by either dragging the small grey icons labeled “S” (for Start)
and “E” (for End) left and right using the mouse, or by entering the Start and End points in
their respective elds.
2 Loop Settings
Here you can dene a Loop by clicking on the Loop Button. The Loop will be repeated as
long as the note is triggered, which can be useful to loop a whole Sample or part of it in order
to simulate a longer tone. The Start and End point can be edited by entering the Start and
End points in their respective elds. Alternatively you can also alter the Start and End of the
Loop by dragging the handles of the Loop and move the entire Loop by dragging its title bar.
Crossfade allows you to dene a crossfade value between the end and the start of the Loop.

Native Instruments Maschine Specifications

General

Weight	4.85 lbs (2.2 kg)
Pads	16 velocity-sensitive pads with aftertouch
Connectivity	USB, MIDI In/Out
Software	Maschine Software
Compatibility	Mac and PC
Power Supply	USB powered
Audio Interface	No built-in audio interface
Sequencer	Yes, pattern-based sequencer
Sampling	Yes, integrated sampler
Effects	Yes, includes a variety of effects
Encoders	8 knobs with LED ring indicators
DAW Integration	Yes, works as a plugin within most major DAWs