Native Instruments Maschine - Phaser

MASCHINE 1.5 Reference Manual – 146
8.3.5 Phaser
The Phaser on the software
Classic Phaser with LFO and envelope-follower modulators. The Phaser splits the signal into
two parts and continuously modulates the phase of one of them.
Freq
CEntEr This denes the center frequency of the Phaser.
Modulation
amoUnt The amount of modulation.
SoUrCE
Here you can select the modulation source of the Phaser:
available options are EnvElopE, lFo SynC and lFo. Depending
on your selection, the parameter to the right will change:
EnvElopE ShapE Change the Shape of the envelope here.
lFo SpEEd The Speed of the lFo in a range from 0,03 Hz up to 8 Hz.
lFo SynC
Denes the speed of the modulation in musical values
from 16/1 (once every 16 bars) up to 1/16 note.
StErEo This parameter widens the stereo eld of the effect.
Feedback
amoUnt Adjust the amount of the Feedback here.
8polE
Activating this causes the Phaser to use the 8Pole Mode,
resulting in a more intense Phaser effect.
Output mIx
Mix lets you adjust the amount of the effect in relation to
the dry original audio signal.